Am I the only one who spent 5 hours chasing a 1/16 inch out of square on a cabinet carcass
Last week I was building a base cabinet for a client's kitchen down in Eugene and the carcass was out of square by 1/16 inch on the diagonal. I checked my cut list twice, re-measured everything, and still couldn't figure out where it was coming from. Turned out my cheap folding square had gotten knocked around in the truck and was off just enough to throw off my marks. Five hours for a problem a $20 machinist square would have caught in two minutes. Now I'm wondering how many other tools in my box are lying to me, what's the first thing you check when a joint just won't close up right?
A 1/16 inch on the diagonal is small enough that I'd look at the assembly itself before blaming the tools. Wood moves, and if your carcass sat in the shop overnight before you glued it up, the panels can take on a twist or the dados can pull things out of line even when every cut is dead on. A machinist square is a good check on your layout tools, sure, but the first thing I check when a joint won't close is whether the parts are flat and whether my clamps are pulling it crooked. Half the time it's clamp pressure fighting me, not a bad square. I keep a cheap 3 inch engineer square in my apron just to rule out the easy stuff, but I wouldn't go replacing every tool in the box over one bad knock in the truck.